General Safety Instructions
Condor 12001-C/15001-C BAH0030-4 07.15
29
Use of the implement
Before starting work, ensure that you understand all the
equipment and actuation elements of the implement and their
function. There is no time for this when the implement is already
in operation!
Wear tight-fitting clothing! There is an increased risk of loose
clothing getting caught or entangled on drive shafts!
Only place the implement in service after all protective devices
have been attached and are in protective position!
Comply with the maximum load of the connected implement and
the approved axle and support loads of the tractor. If necessary,
drive only with a partially filled hopper.
It is forbidden to stand in the working area of the implement.
It is forbidden to stand in the turning and swivel range of the
implement.
There are crushing and shearing hazards on implement parts
actuated by external force (e.g. hydraulically)!
Only actuate implement parts actuated by external force if
personal are maintaining an adequate safety distance to the
implement!
Secure the tractor against unintentional start-up and rolling,
before you leave the tractor.
For this:
Lower the implement onto the ground.
Apply the tractor parking brake.
Switch off the tractor engine.
Remove the ignition key.
Implement transportation
When using public roads, national road traffic regulations must
be observed.
Before moving off, check:
the correct connection of the supply lines,
the lighting system for damage, function and cleanliness,
the brake and hydraulic system for visible damage,
that the tractor parking brake is released completely.
the function of the brake system.
Ensure that the tractor has sufficient steering and braking power.
Any implements and front/rear weights connected to the tractor
influence the driving behaviour and the steering and braking
power of the tractor.
If necessary, use front weights.
The front tractor axle must always be loaded with at least 20 %
of the empty tractor weight, in order to ensure sufficient steering
power.
Always fix the front or rear weights to the intended fixing points
according to regulations.