General Safety Instructions
30
Condor 12001-C/15001-C BAH0030-4 07.15
Comply with the maximum load of the connected implement and
the approved axle and support loads of the tractor.
The tractor must guarantee the prescribed brake delay for the
loaded vehicle combination (tractor plus connected implement).
Check the brake power before moving off.
When turning corners with the implement coupled, take the wide
sweep and centrifugal mass of the implement into account.
Before moving off, ensure sufficient side locking of the tractor
lower links, when the implement is fixed to the three-point
hydraulic system or lower links of the tractor.
Before road transport, move all the swivel implement parts to the
transport position.
Before road transport, secure all the swivel implement parts in
the transport position against risky position changes. Use the
transport locks intended for this.
Before road transport, secure the operating lever of the three-
point hydraulic system against unintentional raising or lowering
of the coupled implement.
Check that the transport equipment, e.g. lighting, warning
equipment and protective equipment, is correctly mounted on the
implement.
Before road transport, carry out a visual check that the top and
lower link bolts are firmly fixed with the linch pin against
unintentional release.
Adjust your forward speed to the prevailing conditions.
Before driving downhill, switch to a low gear.
Before road transport, always switch off the independent wheel
braking (lock the pedals).
To Next Page
Loading...
Need help?
General
