Amazone Precea 3000 - Page 143

19. The required spread rate is not reached during
the  calibration test.
Using the values for the first calibration,
determine the gearbox position for the desired
spread rate, see "Determining the gearbox
position with the calculator disc".
20. Repeat the calibration until the desired quantity is
metered.
NOTE
If the desired spread rate is not reached, contact
your specialist workshop for more information.
21. Empty the calibration bucket.
22. To prevent soiling of the calibration buckets,
slide the calibration bucket
1
under the metering
unit with the opening facing down.
23. Swivel up the lock
2
and close it.
24. To move the calibration  lever into working
position,
press and hold the lock button and push it
upwards.
CMS-I-00001932
6.4.16.4 Determining the gearbox position with the calculator disc
Determined spread rate 175 kg/ha
1
Utilised gearbox position 70
2
Desired spread rate 125 kg/ha
3
Gearbox position 50
4
for the desired spread
rate
CMS-I-00002787
1. Align the determined spread rate
1
with the
gearbox position 70
2
on the calculator disc.
2. Read the gearbox position
4
for the desired
spread rate
3
from the calculator disc.
CMS-T-00003671-A.1
6 | Preparing the machine
Preparing the implement for operation
MG6660-EN-II | D.1 | 27.09.2021
137