4. Install the air supply
on the air distributor.
5. Install the clamp
.
CMS-I-00003919
6.4.23.5 Removing the PreTeC coulter
6.4.23.5.1 Removing the coulter
NOTE
Rows with a contact force sensor
may not
be removed. The contact force sensor can be
recognised by the signal processing
.
CMS-I-00003921
1. To remove the desired coulter,
see "Disconnecting the air and fertiliser supply".
2. see "Disconnecting the energy supply".
3. If the implement is equipped with a hydraulic
coulter pressure system,
see "Disconnecting the hydraulic supply".
CMS-T-00005471-B.1
CMS-T-00005475-B.1
6 | Preparing the machine
Preparing the implement for operation
MG6660-EN-II | D.1 | 27.09.2021
153
To Next Page
Loading...
