Amazone Precea 3000 - Page 215

4. Release the lock
1
until the points
2
are
aligned.
1
2
CMS-I-00001910
5. remove the singling disc
1
from the drive hub.
1
CMS-I-00001912
6. To clean the opto-sensor, use tap water with
dishwashing detergent.
Loosen contamination with the supplied brush for
1 minute
7. Rinse the opto-sensor with clear fresh water.
8. Install the singling disc.
9. Install the cover.
10. To remove stubborn contamination, remove the
opto-sensor.
Remove the spring cotter pin
1
.
CMS-I-00003814
9 | Repairing the machine
Maintaining the machine
MG6660-EN-II | D.1 | 27.09.2021
209