Unit :
Domain :
Recipient 1:
Recipient 2:
*** Trigger 1
Serial Sequence: 00,00
CP1: X
CP2: X
CP3: X
Message :
Priority: L
Min. notification interval: 0 s
Re-notification interval : 0 s
*** Trigger 2
Serial Sequence: 00,00
CP1: X
CP2: X
CP3: X
Message :
Priority: L
Min. notification interval: 0 s
Re-notification interval : 0 s
*** Trigger 3
Serial Sequence: 00,00
CP1: X
CP2: X
CP3: X
Message :
Priority: L
Min. notification interval: 0 s
Re-notification interval : 0 s
Change Setup:
0 Server configuration
1 Channel 1 configuration
3 E-mail settings
5 Expert settings
6 Security
7 Factory defaults
8 Exit without save
9 Save and exit Your choice ?
3. Type 3 (E-mail settings) followed by Enter.
4. Type each part of the Mail Server's IP Address followed by Enter. If you do not want to change a value,
just press Enter to skip.
Mail server (0.0.0.0): (000) 10.(000) 0.(000) 0.(000) 20
5. Type the Unit Name of the Traka system followed by Enter. This will form the first part of the e-mail address
e.g. reception@traka.com.
Unit name (): reception
6. Type the Domain Name of the Traka system followed by Enter. This will form the second part of the e-mail
address e.g. reception@traka.com.
Domain name (): traka.com
7. Type the e-mail address of the first Recipient followed by Enter.
Recipient 1 (): djw@traka.com
8. Optionally type the e-mail address of the second Recipient followed by Enter. A second recipient e-mail
address does not have to be specified.
To Next Page
