Assa Abloy TRAKA32 - Diagnostics; To Enter a Systems Diagnostic Mode

V3.5 14/08/19
UD0089
Page 367
This Document is uncontrolled unless over stamped "CONTROLLED DOCUMENT"
3.14.2 DIAGNOSTICS
To load the diagnostics window, click on the Engineers menu from the system viewer, followed by Diagnostics.
To enter a systems diagnostic mode...
1. Select the system you wish to diagnose from System Selection menu.
2. Click on the Connect button, this will open the serial or network port.
(Note that if successful the Connect button changes to Disconnect)
3. Click on the Comms On button, this will wake and enter the system into diagnostic mode.
NOTE: that if successful the Comms On button changes to Comms Off.