System and Position
The system and position fields are used to select where the iFob is located that you wish to program.
Desktop iFob Programmer
To program an iFob using the Traka Desktop iFob Programmer, select Desktop iFob Programmer from the
Posion dropdown menu.
iFob Type
There are two types of iFob the can be used with the Traka Immobilisor...
Service iFob.
A Service iFob has the following functions...
a. allows a user to (re)program a Vehicle iFob.
b. allows a user to drive any truck and access any on-board diagnostics fitted.
c. allows a user to activate any vehicle permanently until the power is cut or the Service iFob
or Vehicle iFob is replaced.
d. allows a user to reset an Immobilisor after a shock.
Program iFob
A Program iFob has one function...
a. allows a user to (re)program a Manufacturers Code, Acceptance Button timer and Shock
Sensor Threshold.
Vehicle iFob
A Vehicle iFob has two functions...
a. when programmed to an Immobilisor using a Service iFob, it allows a user activate that
immobilisor.
b. When the immobilisor is active, the Vehicle iFob can collect data such as shock detection
and vehicle acceptance.
Calibrate iFob
A Calibrate iFob is used to calibrate the options Immobilisor Shock Sensor. This should only be used
by qualified Traka engineers.
Debug (RAM & ROM)
A Debug iFob is used to diagnose problems with the Immobilisor system. This should only be used
by qualified Traka engineers.
Reset iFob
A Reset iFob is used to reset the Minutes Used counter of the Immobilisor. This should only be used
by qualified Traka engineers.
To Next Page
