3.19.5.8 FAULT LOGGING ON IFOB REMOVAL
NOTE: This option is only available on 8bit RFID Lockers with version 6.08.033 firmware.
NOTE: This section assumes the user has prior knowledge of the operation of the Fault Logging feature.
Please read from the start of the Fault Logging section of this guide and then refer to this section on how
to log a fault on iFob removal.
To be able log a fault when removing an iFob, the Fault Logging option will need to be enabled in the systems
firmware. With Fault Logging enabled you have the option of entering a fault code when certain iFobs are removed
from the system. This is configured on an individual iFob basis.
1. From the System Viewer right click the iFob you wish to configure.
2. Select 'Edit iFob Details'.
3. Tick the box that states 'Prompt For Fault On iFob Removal'.
4. Click 'Save & Close'.
5. When a user next removes that iFob they will be asked to enter a fault code.
To Next Page
Loading...
