Data Table
If required, the data in the table can be altered by double clicking over the relevant data. The data can then
be written back to the iFob by clicking on the Write iFob Configuration button.
Clear Memory to Zero
Click this button to set all the data in the data table to 0.
Reset
Once data has been read from the iFob, click the reset button to clear the data table and re-enable the Start
Address and Length controls as well as the Immobilisor tab.
Calc CRC at 0x001F
Click this button to calculate a CRC value based upon the data present in bytes 0x0000 to 0x001E. The
resultant CRC will replace byte 0x001F.
To Next Page
