Firmware has fault logging enabled
This box will be checked if the firmware has fault logging enabled.
Firmware allows faults to be logged at cabinet
This box will be checked if the firmware has the ability to log faults from the keypad.
Default fault code
The drop down list allows a default fault code to be selected. When an iFob is returned, the defined fault code
will automatically be selected unless changed by the user. This option is only available if the firmware allows
faults to be logged at the cabinet.
Firmware has mileage logging enabled
This box will be checked if the firmware has mileage logging enabled.
Firmware has fuel level logging enabled
This box will be checked if the firmware has fuel level logging enabled.
Firmware has location storing enabled
This box will be checked if the firmware has location storing enabled. This is also referred to a Bay Logging.
Firmware has reason code logging enabled
This box will be checked if the firmware has reason code logging enabled.
Firmware has key booking enabled
This box will be checked if the firmware has the key booking utility enabled.
To Next Page
