User's Manual 124 Document #: LTRT-42060
Mediant 2600 E-SBC
Application Traffic / Network Types Class-of-Service (Priority)
Application Types'' on page 115):
OAMP
Control
The following procedure describes how to configure DiffServ-to-VLAN priority mapping in
the Web interface. You can also configure this using the table ini file parameter,
DiffServToVlanPriority or CLI command configure voip > qos vlan-mapping.
To configure QoS:
1. Open the Diff Serv Table page (Configuration tab > VoIP menu > Network > QoS
Settings).
2. Configure DiffServ-to-VLAN priority mapping (Layer-2 QoS):
a. Click Add; the following dialog box appears:
Figure 12-7: DiffServ Table Page - Add Record
b. Configure a DiffServ-to-VLAN priority mapping (Layer-2 QoS) according to the
parameters described in the table below.
c. Click Submit, and then save ("burn") your settings to flash memory.
Table 12-14: DiffServ Table Parameter Descriptions
Parameter Description
Index Defines an index number for the new table record.
Note: Each table row must be configured with a unique index.
Differentiated Services
CLI: diff-serv
[DiffServToVlanPriority_DiffServ]
Defines a DiffServ value.
The valid value is 0 to 63.
VLAN Priority
CLI: vlan-priority
[DiffServToVlanPriority_VlanPriority]
Defines the VLAN priority level.
The valid value is 0 to 7.
3. Under the Differentiated Services group, configure DiffServ (Layer-3 QoS) values per
CoS.
Figure 12-8: QoS Settings Page - Differentiated Services
To Next Page
Loading...
