User's Manual 178 Document #: LTRT-42060
Mediant 2600 E-SBC
DHCP Option Code DHCP Option Name
Option 66 TFTP Server Name
Option 67 Boot file Name
Option 120 SIP Server
Once you have configured the DHCP server, you can configure the following:
DHCP Vendor Class Identifier names (DHCP Option 60) - see ''Configuring the
Vendor Class Identifier'' on page
181
Additional DHCP Options - see ''Configuring Additional DHCP Options'' on page 182
Static IP addresses for DHCP clients - see ''Configuring Static IP Addresses for DHCP
Clients'' on page
184
Note: If you configure additional DHCP Options in the DHCP Option table, they
override the default ones, which are configured in the DHCP Servers table. For
example, if you configure Option 67 in the DHCP Option table, the device uses the
value configured in the DHCP Option table instead of the value configured in the
DHCP Servers table.
To view and delete currently serviced DHCP clients, see ''Viewing and Deleting DHCP
Clients'' on page 185.
The following procedure describes how to configure the DHCP server in the Web interface.
You can also configure this using the table ini file parameter, DhcpServer or CLI command,
configure voip > dhcp server <index>.
To configure the device's DHCP server:
1. Open the DHCP Servers page (Configuration tab > VoIP menu > Services > DHCP
Severs).
2. Click Add; the following dialog box appears:
Figure 15-1: DHCP Servers Table - Add Record Dialog Box
To Next Page
Loading...
