AudioCodes Mediant 2600 User Manual

User's Manual 202 Document #: LTRT-42060
Mediant 2600 E-SBC
2. Click Add; the following dialog box appears:
Figure 15-11: LDAP Configuration Table - Add Record
3. Configure an LDAP server according to the parameters described in the table below.
4. Click Submit.
LDAP Configuration Table Parameter Descriptions
Parameter Description
Index
[LdapConfiguration_In
dex]
Defines an index number for the new table record.
Note: Each table row must be configured with a unique index.
LDAP Server IP
CLI: server-ip
[LdapConfiguration_Ld
apConfServerIp]
Defines the IP address of the LDAP server (in dotted-decimal notation,
e.g., 192.10.1.255).
By default, no IP address is defined.
Note: If you want to use an FQDN for the LDAP server, leave this
parameter undefined and configure the FQDN in the 'LDAP Server
Domain Name' parameter (see below).
LDAP Server Port
CLI: server-port
[LdapConfiguration_Ld
apConfServerPort]
Defines the port number of the LDAP server.
The valid value range is 0 to 65535. The default port number is 389.
LDAP Server Max
Respond Time
CLI: max-respond-time
[LdapConfiguration_Ld
apConfServerMaxResp
ondTime]
Defines the duration (in msec) that the device waits for LDAP server
responses.
The valid value range is 0 to 86400. The default is 3000.
Note: If the response time expires, you can configure the device to use
its local database (Web Users table) for authenticating the user. For
more information, see '
Configuring Local Database for Management User
Authentication' on page 211.
LDAP Server Domain
Name
CLI: domain-name
[LdapConfiguration_Ld
apConfServerDomainN
ame]
Defines the domain name (FQDN) of the LDAP server. The device tries
to connect to the LDAP server according to the IP address listed in the
received DNS query. If there is no connection to the LDAP server or the
connection to the LDAP server fails, the device tries to connect to the
LDAP server with the next IP address in the DNS query list.
Note: The 'LDAP Server IP' parameter takes precedence over this
parameter. Thus, if you want to use an FQDN, leave the 'LDAP Server
IP' parameter undefined.

AudioCodes Mediant 2600 Specifications

General

Brand	AudioCodes
Model	Mediant 2600
Category	Controller
Language	English