User's Manual 210 Document #: LTRT-42060
Mediant 2600 E-SBC
The handling of LDAP queries with the LDAP cache is shown in the flowchart below:
Figure 15-16: LDAP Query Process with Local LDAP Cache
Note: If for the first LDAP query, the result fails for at least one attribute and is
successful for at least one, the partial result is cached. However, for subsequent
queries, the device does not use the partially cached result, but does a new query
with the LDAP server again.
The following procedure describes how to configure the device's LDAP cache in the Web
interface. For a full description of the cache parameters, see 'LDAP Parameters' on page
631.
To Next Page
Loading...
