User's Manual 212 Document #: LTRT-42060
Mediant 2600 E-SBC
To use the Web Users table for authenticating management users:
1. Open the Authentication Settings page (Configuration tab > System menu >
Management > Authentication Settings).
Figure 15-18: Authentication Settings Page - Local Database for Login Authentication
2. Under General Login Authentication Settings:
• Configure when the Web Users table must be used to authenticate login users.
From the 'Use Local Users Database' drop-down list, select one of the following:
♦ When No Auth Server Defined (default): When no LDAP/RADIUS server
is configured (or as fallback if the server is inaccessible).
♦ Always: Always, but if not found, use the LDAP/RADIUS server to
authenticate the user.
• Configure whether the Web Users table must be used to authenticate login users
upon connection timeout with the server. From the 'Behavior upon Authentication
Server Timeout' drop-down list, select one of the following:
♦ Deny Access: User is denied access to the management platform.
♦ Verify Access Locally (default): The device verifies the user's credentials
in the Web Users table.
3. Click Submit.
To Next Page
Loading...
