AudioCodes Mediant 2600 - Page 257

Version 6.8 257 Mediant 2600 E-SBC
User's Manual 17. Control Network
Table 17-4: SIP Interface Table Parameter Descriptions
Parameter Description
Index
[SIPInterface_Index]
Defines an index for the new table record.
Interface Name
CLI: interface-name
[SIPInterface_InterfaceName]
Defines an arbitrary name to easily identify the SIP Interface.
The valid value is a string of up to 21 characters.
Network Interface
CLI: network-interface
[SIPInterface_NetworkInterface]
Assigns a Control-type IP network interface to the SIP
Interface. This string value must be identical (case-sensitive)
to that configured in the 'Interface Name' field of the Interface
table (see ''Configuring IP Network Interfaces'' on page 112).
By default, no value is defined.
Application Type
CLI: application-type
[SIPInterface_ApplicationType]
Defines the application type associated with the SIP
Interface.

[2]
SBC = SBC application.
UDP Port
CLI: udp-port
[SIPInterface_UDPPort]
Defines the listening and source UDP port.
The valid range is 1 to 65534. The default is 5060.
Notes:
 This port must be outside of the RTP port range.
 The base UDP port number (BaseUDPPort parameter)
for RTP traffic must be greater than the highest UDP port
configured for a SIP Interface. For example, if your
highest configured UDP port for a SIP Interface is 6060,
you must configure the BaseUDPPort parameter to any
value greater than 6060. For more information on base
UDP port, see Configuring RTP Base UDP Port on page
171.
 Each SIP Interface must have a unique signaling port
(i.e., no two SIP Interfaces can share the same port - no
port overlapping).
TCP Port
CLI: tcp-port
[SIPInterface_TCPPort]
Defines the listening TCP port.
The valid range is 1 to 65534. The default is 5060.
Notes:
 This port must be outside of the RTP port range.
 Each SIP Interface must have a unique signaling port
(i.e., no two SIP Interfaces can share the same port - no
port overlapping).
TLS Port
CLI: tls-port
[SIPInterface_TLSPort]
Defines the listening TLS port.
The valid range is 1 to 65534. The default is 5061.
Notes:
 This port must be outside of the RTP port range.
 Each SIP Interface must have a unique signaling port
(i.e., no two SIP Interfaces can share the same port - no
port overlapping).