AudioCodes Mediant 2600 - Page 268

User's Manual 268 Document #: LTRT-42060
Mediant 2600 E-SBC
Parameter Description
Group fails.
 If the device receives an INVITE as a result of a REFER request
or a 3xx response, then the incoming INVITE is routed according
to the Request-URI. The device identifies such INVITEs
according to a specific prefix in the Request-URI header,
configured by the SBCXferPrefix parameter. Therefore, in this
scenario, the device ignores this parameter setting.
Destination URI Input
CLI: dst-uri-input
[IPGroup_DestUriInput]
Defines the SIP header in the incoming INVITE to use as a call
matching characteristic based on destination URIs. The parameter is
used for classification and routing purposes. The device first uses
the parameter’s settings as a matching characteristic (input) to
classify the incoming INVITE to an IP Group (source IP Group) in the
Classification table. Once classified, the device uses the parameter
for routing the call. For example, if set to To, the URI in the To
header of the incoming INVITE is used as a matching characteristic
for classifying the call to an IP Group in the Classification table. Once
classified, the device uses the URI in the To header as the
destination.
 [-1] Not Configured (default)
 [0] From
 [1] To
 [2] Request-URI
 [3] P-Asserted - First Header
 [4] P-Asserted - Second Header
 [5] P-Preferred
 [6] Route
 [7] Diversion
 [8] P-Associated-URI
 [9] P-Called-Party-ID
 [10] Contact
 [11] Referred-by
Notes:
 The parameter is applicable only when classification is done
according to the Classification table.
 If the configured SIP header does not exist in the incoming
INVITE message, the classification of the message to a source IP
Group fails.
 If the device receives an INVITE as a result of a REFER request
or a 3xx response, the incoming INVITE is routed according to
the Request-URI. The device identifies such INVITEs according
to a specific prefix in the Request-URI header, configured by the
SBCXferPrefix parameter. Therefore, in this scenario, the device
ignores this parameter setting.