AudioCodes Mediant 2600 - Page 288

User's Manual 288 Document #: LTRT-42060
Mediant 2600 E-SBC
Parameter Description
ndition]

header.from.url.user== '100' (indicates that the user part of the
From header must have the value "100")
 header.contact.param.expires > '3600'
 header.to.url.host contains 'domain'
 param.call.dst.user != '100'
Operation
Action Subject
CLI: action-subject
[MessageManipulations_Act
ionSubject]
Defines the SIP header upon which the manipulation is performed.
The valid value is a string (case-insensitive).
Action Type
CLI: action-type
[MessageManipulations_Act
ionType]
Defines the type of manipulation.
 [0] Add (default) = Adds new header/param/body (header or
parameter elements).
 [1] Remove = Removes header/param/body (header or
parameter elements).
 [2] Modify = Sets element to the new value (all element types).
 [3] Add Prefix = Adds value at the beginning of the string (string
element only).
 [4] Add Suffix = Adds value at the end of the string (string
element only).
 [5] Remove Suffix = Removes value from the end of the string
(string element only).
 [6] Remove Prefix = Removes value from the beginning of the
string (string element only).
 [7] Normalize = Removes unknown SIP message elements
before forwarding the message.
Action Value
CLI: action-value
[MessageManipulations_Act
ionValue]
Defines a value that you want to use in the manipulation.
The default value is a string (case-insensitive) in the following
syntax:
 string/<message-element>/<call-param> +
 string/<message-element>/<call-param>
For example:
 'itsp.com'
 header.from.url.user
 param.call.dst.user
 param.call.dst.host + '.com'
 param.call.src.user + '<' + header.from.url.user + '@' + header.p-
asserted-id.url.host + '>'
Note: Only single quotation marks must be used.
Row Role
CLI: row-role
[MessageManipulations_Ro
wRole]
Determines which message manipulation condition (configured by
the 'Condition' parameter) to use for the rule.
 [0] Use Current Condition = (Default) The condition configured in
the table row of the rule is used.
 [1] Use Previous Condition = The condition configured in the first
table row above the rule that is configured to Use Current
Condition is used. For example, if Index 3 is configured to Use
Current Condition and Index 4 and 5 are configured to Use
Previous Condition, Index 4 and 5 use the condition configured
for Index 3. A configuration example is shown in the beginning of
this section. The option allows you to use the same condition for