AudioCodes Mediant 2600 - Page 290

User's Manual 290 Document #: LTRT-42060
Mediant 2600 E-SBC
2. Click Add; the following dialog box appears:
Figure 18-6: Message Policy Table - Add Record Dialog Box
3. Configure a Message Policy rule according to the parameters described in the table
below.
4. Click Submit, and then save ("burn") your settings to flash memory.
Table 18-3: Message Policy Table Parameter Descriptions
Parameter Description
Index
[MessagePolicy_Index]
Defines an index number for the new table record.
Max Message Length
CLI: max-message-length
[MessagePolicy_MaxMessageLength]
Defines the maximum SIP message length.
The valid value is up to 32,768 characters. The default is
32,768.
Max Header Length
CLI: max-header-length
[MessagePolicy_MaxHeaderLength]
Defines the maximum SIP header length.
The valid value is up to 512 characters. The default is 512.
Max Body Length
CLI: max-body-length
[MessagePolicy_MaxBodyLength]
Defines the maximum SIP message body length. This is
the value of the Content-Length header.
The valid value is up to 1,024 characters. The default is
1,024.
Max Num Headers
CLI: max-num-headers
[MessagePolicy_MaxNumHeaders]
Defines the maximum number of SIP headers.
The valid value is any number up to 32. The default is 32.
Note: The device supports up to 20 SIP Record-Route
headers that can be received in a SIP INVITE request or
200 OK response. If it receives more than this, it responds
with a SIP 513 'Message Too Large' response.
Max Num Bodies
CLI: max-num-bodies
[MessagePolicy_MaxNumBodies]
Defines the maximum number of bodies (e.g., SDP) in the
SIP message.
The valid value is any number up to 8. The default is 8.