User's Manual 306 Document #: LTRT-42060
Mediant 2600 E-SBC
Parameter Description
Web: Diversion Mode
CLI: sbc-diversion-mode
[IpProfile_SBCDiversionMode]
Defines the device’s handling of the SIP Diversion header for this
SIP entity. For more information on interworking of the History-Info
and Diversion headers, see Interworking SIP Diversion and
History-Info Headers on page 339.
[0] As Is = (Default) Diversion header is not handled.
[1] Add = History-Info header is converted to a Diversion
header.
[2] Remove = Removes the Diversion header and the
conversion to the History-Info header depends on the settings of
the SBCHistoryInfoMode parameter.
Note: If the Diversion header is used, you can specify the URI type
(e.g., "tel:") to use in the header, using the SBCDiversionUriType
parameter.
Web: History-Info Mode
CLI: sbc-history-info-mode
[IpProfile_SBCHistoryInfoMode]
Defines the device’s handling of the SIP History-Info header for this
SIP entity. For more information on interworking of the History-Info
and Diversion headers, see Interworking SIP Diversion and
History-Info Headers on page 339.
[0] As Is = (Default) History-Info header is not handled.
[1] Add = Diversion header is converted to a History-Info
header.
[2] Remove = History-Info header is removed from the SIP
dialog and the conversion to the Diversion header depends on
the settings of the SBCDiversionMode parameter.
Web: Fax Coders Group ID
CLI: sbc-fax-coders-group-id
[IpProfile_SBCFaxCodersGroup
ID]
Assigns a Coders Group ID to define the supported fax coders for
fax negotiation for this SIP entity. For configuring Coder Groups,
see Configuring Coder Groups on page 296.
Note: The parameter is applicable only if you set the
IpProfile_SBCFaxBehavior parameter to a value other than [0].
Web: Fax Behavior
CLI: sbc-fax-behavior
[IpProfile_SBCFaxBehavior]
Defines the fax-offer negotiation method for this SIP entity.
[0] As Is = (Default) Pass fax transparently, without interference.
[1] Handle always = Handle fax according to fax settings in the
IP Profile for all offer-answer transactions (including the initial
INVITE).
[2] Handle on re-INVITE = Handle fax according to fax settings
in the IP Profile for all re-INVITE offer-answer transactions
(except for initial INVITE).
Note: The fax settings in the IP Profile include
IpProfile_SBCFaxCodersGroupID, IpProfile_SBCFaxOfferMode,
and IpProfile_SBCFaxAnswerMode.
Web: Fax Offer Mode
CLI: sbc-fax-offer-mode
[IpProfile_SBCFaxOfferMode]
Defines the coders included in the outgoing SDP offer (sent to the
called "fax") for this SIP entity.
[0] All coders = (Default) Use only (and all) the coders of the
selected Coders Group ID configured using the
SBCFaxCodersGroupID parameter.
[1] Single coder = Use only one coder. If a coder in the
incoming offer (from the calling "fax") matches a coder in the
SBCFaxCodersGroupID, then the device uses this coder. If no
match exists, then the device uses the first coder listed in the
Coders Group ID (SBCFaxCodersGroupID).
Note: The parameter is applicable only if you set the
IpProfile_SBCFaxBehavior parameter to a value other than [0].
To Next Page
Loading...
