AudioCodes Mediant 2600 - Page 357

Version 6.8 357 Mediant 2600 E-SBC
User's Manual 21. SBC Configuration
Table 21-1: Admission Control Table Parameter Description
Parameter Description
Index
[SBCAdmissionControl_Index]
Defines an index number for the new table record.
Admission Name
CLI: admission-name
[SBCAdmissionControl_Admissi
onControlName]
Defines an arbitrary name to easily identify the Admission
Control rule.
The valid value is a string of up to 20 characters. By default, no
value is defined.
Limit Type
CLI: limit-type
[SBCAdmissionControl_LimitTy
pe]
Defines the entity to which the rule applies.
 [0] IP Group (default)
 [1] SRD
IP Group ID
CLI: ip-group-id
[SBCAdmissionControl_IPGroup
ID]
Defines the IP Group to which you want to apply the rule.
The default value is -1 (i.e., all IP Groups).
Note: This parameter is applicable only if 'Limit Type' is set to
IP
Group.
SRD ID
CLI: srd-id
[SBCAdmissionControl_SRDID]
Defines the SRD to which you want to apply the rule.
The default value is -1 (i.e., all SRDs).
Note: This parameter is applicable only if 'Limit Type' is set to
SRD.
Request Type
CLI: request-type
[SBCAdmissionControl_Request
Type]
Defines the SIP dialog-initiating request type to which you want
to apply the rule (not the subsequent requests that can be of
different type and direction).
 [0] All = (Default) Includes the total number of all dialogs.
 [1] INVITE
 [2] SUBSCRIBE
 [3] Other
Request Direction
CLI: request-direction
[SBCAdmissionControl_Request
Direction]
Defines the direction of the SIP request to which the rule
applies.
 [0] Both = (Default) Rule applies to inbound and outbound
SIP dialogs.
 [1] Inbound = Rule applies only to inbound SIP dialogs.

[2]
Outbound = Rule applies only to outbound SIP dialogs.
Limit
CLI: limit
[SBCAdmissionControl_Limit]
Defines the maximum number of concurrent SIP dialogs per IP
Group or SRD. You can also use the following special values:
 [0] 0 = Block all these dialogs.

[-1]
-1 = (Default) Unlimited.
Limit Per User
CLI: limit-per-user
[SBCAdmissionControl_LimitPer
User]
Defines the maximum number of concurrent SIP dialogs per
user belonging to the specified IP Group or SRD. You can also
use the following special values:
 [0] 0 = Block all these dialogs.

[-1]
-1 = (Default) Unlimited.