AudioCodes Mediant 2600 - Page 365

Version 6.8 365 Mediant 2600 E-SBC
User's Manual 21. SBC Configuration
Parameter Description
wildcards:
 "x" wildcard: represents single digits. For example,
10.8.8.xx represents all the addresses between 10.8.8.10
to 10.8.8.99.
 asterisk (*) wildcard: represents any number between 0
and 255. For example, 10.8.8.* represents all addresses
between 10.8.8.0 and 10.8.8.255.
If this parameter is not configured or is configured as an
asterisk (*), any source IP address is accepted.
Note:
 The parameter is applicable only to Server-type IP
Groups.
 If the IP address is unknown (i.e., configured for the
associated Proxy Set as an FQDN), it is recommended to
classify incoming dialogs based on Proxy Set (instead of
using a Classification rule). For more information on
classification by Proxy Set or by Classification rule, see
the note bulletin in the beginning of this section.
Source Port
CLI: src-port
[Classification_SrcPort]
Defines the source port number of the incoming SIP dialog.
Source Transport Type
CLI: src-transport-type
[Classification_SrcTransportType]
Defines the source transport type (UDP, TCP, or TLS) of the
incoming SIP dialog.
 [-1] ANY (Default) = All transport types
 [0] UDP
 [1] TCP
 [2] TLS
Source Username Prefix
CLI: src-user-name-prefix
[Classification_SrcUsernamePrefix]
Defines the prefix of the source URI user part of the
incoming SIP dialog. The URI is typically located in the SIP
From header. However, you can configure the SIP header
from where the device obtains the source URI. This is done
in the IP Group table, using the 'Source URI Input'
parameter. For more information on how the device obtains
this URI, see ''SIP Dialog Initiation Process'' on page 321.
The default is the asterisk (*) symbol, which represents any
source username prefix. The prefix can be a single digit or a
range of digits. For available notations, see ''Dialing Plan
Notation for Routing and Manipulation'' on page 531.
Note: For REGISTER requests, the source URL is obtained
from the To header.
Source Host
CLI: src-host
[Classification_SrcHost]
Defines the prefix of the source URI host name. The URI is
typically located in the SIP From header. However, you can
configure the SIP header from where the device obtains the
source URI. This is done in the IP Group table, using the
'Source URI Input' parameter. For more information on how
the device obtains this URI, see ''SIP Dialog Initiation
Process'' on page 321.
The default is the asterisk (*) symbol, which represents any
source host prefix.
Note: For REGISTER requests, the source URL is obtained
from the To header.