Version 6.8 511 Mediant 2600 E-SBC
User's Manual 39. Syslog and Debug Recordings
To activate the Web interface's Message Log:
1. Enable Syslog (see ''Enabling Syslog'' on page 505).
2. Open the Message Log page (Status & Diagnostics tab > System Status menu >
Message Log); the Message Log page is displayed and the log is activated.
Figure 39-5: Message Log Page
The displayed logged messages are color-coded as follows:
• Yellow - fatal error message
• Blue - recoverable error message (i.e., non-fatal error)
• Black - notice message
To stop and clear the Message Log:
Close the Message Log page by accessing any another page in the Web interface.
To Next Page
Loading...
