AudioCodes Mediant 2600 - Page 518

User's Manual 518 Document #: LTRT-42060
Mediant 2600 E-SBC
3. Configure a test call according to the parameters described in the table below.
4. Click Submit, and then save ("burn") your settings to flash memory.
Table 41-1: Test Call Table Parameter Descriptions
Parameter Description
General Tab
Endpoint URI
CLI: endpoint-uri
[Test_Call_EndpointURI]
Defines the endpoint's URI. This can be defined as a user or
user@host. The device identifies this endpoint only by the URI's
user part. The URI's host part is used in the SIP From header in
REGISTER requests.
The valid value is a string of up to 150 characters. By default, this
parameter is not configured.
Called URI
CLI: called-uri
[Test_Call_CalledURI]
Defines the destination (called) URI (user@host).
The valid value is a string of up to 150 characters. By default, this
parameter is not configured.
Route By
CLI: route-by
[Test_Call_RouteBy]
Defines the type of routing method. This applies to incoming and
outgoing calls.
 [0] GW Tel2IP = (Default) Calls are matched by (or routed to)
an SRD and Application type (defined in the SRD and
Application Type parameters below).
 [1] IP Group = Calls are matched by (or routed to) an IP Group
ID.
 [2]
Dest Address = Calls are matched by (or routed to) an SRD
and application type.
Notes:
 For REGISTER messages, the option [0] cannot be used as
the routing method.
 For REGISTER messages, if option [1] is used, only Server-
type IP Groups can be used.
IP Group ID
CLI: ip-group-id
[Test_Call_IPGroupID]
Defines the IP Group ID to which the test call is sent or from
which it is received.
Notes:
 This parameter is applicable only if option [1] is configured for
the 'Route By' parameter.
 This IP Group is used for incoming and outgoing calls.
Destination Address
CLI: dst-address
[Test_Call_DestAddress]
Defines the destination host. This can be defined as an IP
address[:port] or DNS name[:port].
Note: This parameter is applicable only if the 'Route By'
parameter is set to [2] (Dest Address).
Destination Transport Type
CLI: dst-transport
[Test_Call_DestTransportType]
Defines the transport type for outgoing calls.
 [-1] = Not configured (default)
 [0] UDP
 [1] TCP
 [2] TLS
Note: This parameter is applicable only if the 'Route By'
parameter is set to [2] (Dest Address).