Version 6.8 55 Mediant 2600 E-SBC
User's Manual 6. Web-Based Management
The following procedure describes how to configure Web users in the Web interface. You
can also configure this using the CLI command configure system > create-users-table.
To add Web user accounts with advanced settings:
1. Open the Web Users Table page:
• Upon initial access:
a. Open the Web User Accounts page (Configuration tab > System menu >
Web User Accounts).
b. Under the Web Users Table group, click the Create Table button.
• Subsequent access: Configuration tab > System menu > Web User Accounts.
The Web Users table appears, listing the two default, pre-configured Web use
accounts - Security Administrator ("Admin") and Monitor ("User"):
Figure 6-17: Web Users Table Page
2. Click Add; the following dialog box is displayed:
Figure 6-18: Web Users Table - Add Record Dialog Box
3. Configure a Web user according to the parameters described in the table below.
4. Click Submit, and then save ("burn") your settings to flash memory.
Table 6-11: Web User Table Parameter Descriptions
Parameter Description
Index Defines an index number for the new table record.
Note: Each table row must be configured with a unique index.
Web: Username
CLI: user
Defines the Web user's username.
The valid value is a string of up to 40 alphanumeric characters,
including the period ".", underscore "_", and hyphen "-" signs.
Web: Password Defines the Web user's password.
To Next Page
Loading...
