EasyManua.ls Logo

AudioCodes Mediant 2600 - Page 552

AudioCodes Mediant 2600
646 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
User's Manual 552 Document #: LTRT-42060
Mediant 2600 E-SBC
Parameter Description
EMS: Binding Life Time
[NATBindingDefaultTimeout]
The device sends SNMP keep-alive traps periodically - every 9/10
of the time configured by this parameter (in seconds). Therefore,
the parameter is applicable only if the SendKeepAliveTrap
parameter is set to 1.
The parameter is used to allow SNMP communication with
AudioCodes EMS management platform, located in the WAN,
when the device is located behind NAT. It is needed to keep the
NAT pinhole open for the SNMP messages sent from EMS to the
device.
The valid range is 0 to 2,592,000. The default is 30.
Note: For this parameter to take effect, a device reset is required.

Table of Contents

Other manuals for AudioCodes Mediant 2600

Related product manuals