User's Manual 580 Document #: LTRT-42060
Mediant 2600 E-SBC
Parameter Description
Proxy Registration Parameters
Web/EMS: Proxy Name
CLI: proxy-name
[ProxyName]
Defines the Home Proxy domain name. If specified, this name
is used as the Request-URI in REGISTER, INVITE and other
SIP messages, and as the host part of the To header in INVITE
messages. If not specified, the Proxy IP address is used
instead.
The valid value is a string of up to 49 characters.
Note: This parameter functions together with the
UseProxyIPasHost parameter.
Web: Use Proxy IP as Host
CLI: use-proxy-ip-as-host
[UseProxyIPasHost]
Enables the use of the proxy server's IP address (in dotted-
decimal notation) as the host name in SIP From and To
headers in REGISTER requests.
[0] Disable (default)
[1] Enable
If this parameter is disabled and the device registers to an IP
Group (i.e., proxy server), it uses the string configured by the
ProxyName parameter as the host name in the REGISTER's
Request-URI and uses the string configured by the IP Group
table parameter, SIPGroupName as the host name in the To
and From headers. If the IP Group is configured with a Proxy
Set that has multiple IP addresses, all the REGISTER
messages sent to these proxies are sent with the same host
name.
Note: If this parameter is disabled and the ProxyName
parameter is not configured, the proxy's IP address is used as
the host name in the REGISTER Request-URI.
Web: Redundancy Mode
EMS: Proxy Redundancy Mode
CLI: redundancy-mode
[ProxyRedundancyMode]
Determines whether the device switches back to the primary
Proxy after using a redundant Proxy.
[0] Parking = (Default) The device continues working with a
redundant (now active) Proxy until the next failure, after
which it works with the next redundant Proxy.
[1] Homing = The device always tries to work with the
primary Proxy server (i.e., switches back to the primary
Proxy whenever it's available).
Note: To use this Proxy Redundancy mechanism, you need to
enable the keep-alive with Proxy option, by setting the
parameter EnableProxyKeepAlive to 1 or 2.
Web: Proxy IP List Refresh Time
EMS: IP List Refresh Time
CLI: proxy-ip-lst-rfrsh-time
[ProxyIPListRefreshTime]
Defines the time interval (in seconds) between each Proxy IP
list refresh.
The range is 5 to 2,000,000. The default interval is 60.
Web/EMS: Always Use Proxy
CLI: always-use-proxy
[AlwaysSendToProxy]
Determines whether the device sends SIP messages and
responses through a Proxy server.
[0] Disable = (Default) Use standard SIP routing rules.
[1] Enable = All SIP messages and responses are sent to
the Proxy server.
Note: This parameter is applicable only if a Proxy server is
used (i.e., the parameter IsProxyUsed is set to 1).
Web/EMS: DNS Query Type
CLI: dns-query
Enables the use of DNS Naming Authority Pointer (NAPTR)
and Service Record (SRV) queries to resolve Proxy and
Registrar servers and to resolve all domain names that appear
To Next Page
Loading...
