AudioCodes Mediant 2600 - Page 591

Version 6.8 591 Mediant 2600 E-SBC
User's Manual 43. Configuration Parameters Reference
Parameter Description

OS=<voice octets sent>
 PR=<voice packets received>
 OR=<voice octets received>
 PL=<receive packet loss>
 JI=<jitter in ms>
 LA=<latency in ms>
Below is an example of the X-RTP-Stat header in a SIP BYE message:
BYE sip:302@10.33.4.125 SIP/2.0
Via: SIP/2.0/UDP
10.33.4.126;branch=z9hG4bKac2127550866
Max-Forwards: 70
From:
<sip:401@10.33.4.126;user=phone>;tag=1c2113553324
To: <sip:302@company.com>;tag=1c991751121
Call-ID: 991750671245200001912@10.33.4.125
CSeq: 1 BYE
X-RTP-Stat:
PS=207;OS=49680;;PR=314;OR=50240;PL=0;JI=600;LA=40;
Supported: em,timer,replaces,path,resource-priority
Allow:
REGISTER,OPTIONS,INVITE,ACK,CANCEL,BYE,NOTIFY,PRACK,
REFER,INFO,SUBSCRIBE,UPDATE
User-Agent: Sip-Gateway-/v.6.80.010.006
Reason: Q.850 ;cause=16 ;text="local"
Content-Length: 0
Web/EMS: Enable Early
Media
CLI: early-media
[EnableEarlyMedia]
Global parameter that enables the Early Media feature for sending media
(e.g., ringing) before the call is established. You can also configure this
functionality per specific calls, using IP Profiles
(IpProfile_EnableEarlyMedia). For a detailed description of this
parameter and for configuring this functionality in the IP Profile table, see
''Configuring IP Profiles'' on page 297.
Note: If this functionality is configured for a specific IP Profile, the
settings of this global parameter is ignored for calls associated with the IP
Profile.
Web: Session-Expires
Time
EMS: Sip Session Expires
CLI: session-expires-time
[SIPSessionExpires]
Defines the numerical value sent in the Session-Expires header in the
first INVITE request or response (if the call is answered).
The valid range is 1 to 86,400 sec. The default is 0 (i.e., the Session-
Expires header is disabled).
Web: Minimum Session-
Expires
EMS: Minimal Session
Refresh Value
CLI: min-session-expires
[MinSE]
Defines the time (in seconds) that is used in the Min-SE header. This
header defines the minimum time that the user agent refreshes the
session.
The valid range is 10 to 100,000. The default is 90.
Web/EMS: Session
Expires Disconnect Time
CLI: session-exp-
disconnect-time
[SessionExpiresDiscon
Defines a session expiry timeout.
The new session expiry timeout is calculated by subtracting the
configured value from the original timeout as specified in the Session-
Expires header. However, the new timeout must be greater than or equal
to one-third (1/3) of the Session-Expires value. If the refresher does not