User's Manual 594 Document #: LTRT-42060
Mediant 2600 E-SBC
Parameter Description
CLI: sip-tcp-local-port
[TCPLocalSIPPort]
The valid range is 1 to 65535. The default is 5060.
Web: SIP TLS Local Port
EMS: TLS Local SIP Port
CLI: sip-tls-local-port
[TLSLocalSIPPort]
Defines the local TLS port for SIP messages.
The valid range is 1 to 65535. The default is 5061.
Note: The value of this parameter must be different from the value of the
parameter TCPLocalSIPPort.
Web: Display Default SIP
Port
CLI: display-default-sip-
port
[DisplayDefaultSIPPort]
Enables the device to add the default SIP port 5060 (UDP/TCP) or 5061
(TLS) to outgoing messages that are received without a port. This
condition also applies to manipulated messages where the resulting
message has no port number. The device adds the default port number
to the following SIP headers: Request-Uri, To, From, P-Asserted-Identity,
P-Preferred-Identity, and P-Called-Party-ID. If the message is received
with a port number other than the default, for example, 5070, the port
number is not changed.
An example of a SIP From header with the default port is shown below:
From:
<sip:+4000@10.8.4.105:5060;user=phone>;tag=f25419a96
a;epid=009FAB8F3E
[0] Disable (default)
Enable
Web/EMS: Enable SIPS
CLI: enable-sips
[EnableSIPS]
Enables secured SIP (SIPS URI) connections over multiple hops.
[0] Disable (default)
[1] Enable
When the SIPTransportType parameter is set to 2 (i.e., TLS) and the
parameter EnableSIPS is disabled, TLS is used for the next network hop
only. When the parameter SIPTransportType is set to 2 or 1 (i.e., TCP or
TLS) and EnableSIPS is enabled, TLS is used through the entire
connection (over multiple hops).
Note: If this parameter is enabled and the parameter SIPTransportType
is set to 0 (i.e., UDP), the connection fails.
Web/EMS: Enable TCP
Connection Reuse
CLI: tcp-conn-reuse
[EnableTCPConnection
Reuse]
Enables the reuse of the same TCP connection for all calls to the same
destination.
[0] Disable = Uses a separate TCP connection for each call.
[1] Enable = (Default) Uses the same TCP connection for all calls.
Note: For the SAS application, this feature is configured using the
SASConnectionReuse parameter.
Web: Fake TCP alias
CLI: fake-tcp-alias
[FakeTCPalias]
Enables the re-use of the same TCP/TLS connection for sessions with
the same user, even if the "alias" parameter is not present in the SIP Via
header of the first INVITE.
[0] Disable = (Default) TCP/TLS connection reuse is done only if the
"alias" parameter is present in the Via header of the first INVITE.
[1] Enable
Note: To enable TCP/TLS connection re-use, set the
EnableTCPConnectionReuse parameter to 1.
Web/EMS: Reliable
Connection Persistent
Mode
CLI: reliable-conn-
persistent
Enables setting of all TCP/TLS connections as persistent and therefore,
not released.
[0] = (Default) Disable. All TCP connections (except those that are set
to a proxy IP) are released if not used by any SIP dialog\transaction.
[1] = Enable - TCP connections to all destinations are persistent and
To Next Page
Loading...
