User's Manual 614 Document #: LTRT-42060
Mediant 2600 E-SBC
Parameter Description
EMS: No Op Payload Type
CLI: no-operation-interval
[RTPNoOpPayloadType]
Defines the payload type of No-Op packets.
The valid range is 96 to 127 (for the range of Dynamic RTP
Payload Type for all types of non hard-coded RTP Payload
types, refer to RFC 3551). The default is 120.
Note: When defining this parameter, ensure that it doesn't
cause collision with other payload types.
RTP Control Protocol Extended Reports (RTCP XR) Parameters
Web: Enable RTCP XR
EMS: RTCP XR Enable
CLI: voice-quality-monitoring-enable
[VQMonEnable]
Enables voice quality monitoring and RTCP XR, according to
RFC 3611.
[0] Disable (default)
[1] Enable Fully = Calculates voice quality metrics, uses
them for QoE calculations, reports them to SEM (if
configured), and sends them to remote side using RTCP
XR.
[2] Enable Calculation Only = Calculates voice quality
metrics, uses them for QoE calculations, reports them to
SEM (if configured), but does not send them to remote side
using RTCP XR.
Note: For this parameter to take effect, a device reset is
required.
Web: Minimum Gap Size
EMS: GMin
[VQMonGMin]
Defines the voice quality monitoring - minimum gap size
(number of frames).
The default is 16.
Web/EMS: Burst Threshold
[VQMonBurstHR]
Defines the voice quality monitoring - excessive burst alert
threshold.
The default is -1 (i.e., no alerts are issued).
Web/EMS: Delay Threshold
[VQMonDelayTHR]
Defines the voice quality monitoring - excessive delay alert
threshold.
The default is -1 (i.e., no alerts are issued).
Web: R-Value Delay Threshold
EMS: End of Call Rval Delay
Threshold
[VQMonEOCRValTHR]
Defines the voice quality monitoring - end of call low quality
alert threshold.
The default is -1 (i.e., no alerts are issued).
Web: RTCP XR Packet Interval
EMS: Packet Interval
CLI: rtcp-interval
[RTCPInterval]
Defines the time interval (in msec) between adjacent RTCP
XR reports. This interval starts from call establishment. Thus,
the device can send RTCP XR reports during the call, in
addition to at the end of the call. If the duration of the call is
shorter than this interval, RTCP XR is sent only at the end of
the call.
The valid value range is 0 to 65,535. The default is 5,000.
Web: Disable RTCP XR Interval
Randomization
EMS: Disable Interval
Randomization
CLI: disable-RTCP-randomization
[DisableRTCPRandomize]
Determines whether RTCP report intervals are randomized or
whether each report interval accords exactly to the parameter
RTCPInterval.
[0] Disable = (Default) Randomize
[1] Enable = No Randomize
To Next Page
Loading...
