AudioCodes Mediant 2600 - Page 74

User's Manual 74 Document #: LTRT-42060
Mediant 2600 E-SBC
Note: Only row entries whose corresponding check boxes are selected are applied
when clicking Submit; otherwise, settings revert to their defaults.
Table 8-2: SNMP Trap Destinations Parameters Description
Parameter Description
Web: SNMP Manager
[SNMPManagerIsUsed_x]
Enables the SNMP Manager to receive traps and checks
the validity of the configured destination (IP address and
port number).
 [0] (check box cleared) = (Default) Disables SNMP
Manager

[1]
(check box selected) = Enables SNMP Manager
Web: IP Address
[SNMPManagerTableIP_x]
Defines the IP address (in dotted-decimal notation, e.g.,
108.10.1.255) of the remote host used as the SNMP
Manager. The device sends SNMP traps to this IP
address.
Trap Port
[SNMPManagerTrapPort_x]
Defines the port number of the remote SNMP Manager.
The device sends SNMP traps to this port.
The valid value range is 100 to 4000. The default is 162.
Web: Trap User
[SNMPManagerTrapUser]
Associates a trap user with the trap destination. This
determines the trap format, authentication level, and
encryption level.
 v2cParams (default) = SNMPv2 user community string
 SNMPv3 user configured in ''Configuring SNMP V3
Users'' on page 76
Trap Enable
[SNMPManagerTrapSendingEnable_x]
Activates the sending of traps to the SNMP Manager.
 [0] Disable

[1]
Enable (Default)