SIP User's Manual 218 Document #: LTRT-12801
MP-500 MSBG
2. From the 'Caller ID' drop-down list, select one of the following:
• 'Enable': Enables Caller ID generation (FXS) or detection (FXO) for the specific
port.
• 'Disable': Caller ID generation (FXS) or detection (FXO) for the specific port is
disabled.
• Not defined: Caller ID generation (FXS) or detection (FXO) for the specific port is
determined according to the parameter 'Enable Caller ID' (described in
''Configuring Supplementary Services'' on page 170).
3. Click the Submit button to save your
changes.
4. To save the changes to flash memory, refer to ''Saving Configuration'' on page 237.
3.4.5.11.6 Configuring Call Waiting
The 'Call Waiting' page allows you to enable or disable call waiting per device FXS port.
Notes:
• This page is applicable only to FXS interfaces.
• Instead of using this page, you can enable or disable call waiting for all
the device's ports, using the global call waiting parameter 'Enable Call
Waiting' (refer to ''Configuring Supplementary Services'' on page 170).
• You can also configure the Call Waiting table using the ini file table
parameter CallWaitingPerPort (refer to ''SIP Configuration Parameters''
on page 318).
• For additional call waiting configuration, refer to the following
parameters: FirstCallWaitingToneID (in the CPT file),
TimeBeforeWaitingIndication, WaitingBeepDuration,
TimeBetweenWaitingIndications, and NumberOfWaitingIndications.
To Next Page
Loading...
Need help?
General
