EasyManuals Logo

AudioCodes mediapack MP-500 User Manual

AudioCodes mediapack MP-500
574 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #322 background imageLoading...
Page #322 background image
SIP User's Manual 322 Document #: LTRT-12801
MP-500 MSBG
Parameter Description
Web: SIP UDP Local Port
EMS: Local SIP Port
[LocalSIPPort]
Local UDP port for SIP messages.
The valid range is 1 to 65534. The default value is 5060.
Web: SIP TCP Local Port
EMS: TCP Local SIP Port
[TCPLocalSIPPort]
Local TCP port for SIP messages.
The valid range is 1 to 65535. The default value is 5060.
Web: SIP TLS Local Port
EMS: TLS Local SIP Port
[TLSLocalSIPPort]
Local TLS port for SIP messages.
The valid range is 1 to 65535. The default value is 5061.
Note: The value of must be different than the value of 'SIP
TCP Local Port' (TCPLocalSIPPort).
Web/EMS: Enable SIPS
[EnableSIPS]
Enables secured SIP (SIPS URI) connections over multiple
hops.
 [0] Disable (default).
 [1] Enable.
When 'SIP Transport Type' is set to TLS (SIPTransportType
= 2) and 'Enable SIPS' is disabled, TLS is used for the next
network hop only. When 'SIP Transport Type' is set to TCP
or TLS (SIPTransportType = 2 or 1) and 'Enable SIPS' is
enabled, TLS is used through the entire connection (over
multiple hops).
Note: If this parameter is enabled and 'SIP Transport Type'
is set to UDP (SIPTransportType = 0), the connection fails.
Web/EMS: Enable TCP Connection
Reuse
[EnableTCPConnectionReuse]
Enables the reuse of the same TCP connection for all calls
to the same destination.
 [0] Disable = Use a separate TCP connection for each
call.
 [1] Enable = Use the same TCP connection for all calls
(default).
Web/EMS: Reliable Connection
Persistent Mode
[ReliableConnectionPersistentMod
e]
Determines whether all TCP/TLS connections are set as
persistent and therefore, not released.
 [0] = Disable (default) - all TCP connections (except
those that are set to a proxy IP) are released if not used
by any SIP dialog\transaction.
 [1] = Enable - TCP connections to all destinations are
persistent and not released unless the device reaches
70% of its maximum TCP resources.
While trying to send a SIP message connection, reuse policy
determines whether alive connections to the specific
destination are re-used.
Persistent TCP connection ensures less network traffic due
to fewer setting up and tearing down of TCP connections
and reduced latency on subsequent requests due to
avoidance of initial TCP handshake. For TLS, persistent
connection may reduce the number of costly TLS
handshakes to establish security associations, in addition to
the initial TCP connection set up.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the AudioCodes mediapack MP-500 and is the answer not in the manual?

AudioCodes mediapack MP-500 Specifications

General IconGeneral
BrandAudioCodes
Modelmediapack MP-500
CategoryGateway
LanguageEnglish

Related product manuals