SIP User's Manual 350 Document #: LTRT-12801
MP-500 MSBG
Parameter Description
Web: Tel Profile Settings Table
EMS: Protocol Definition > Telephony Profile
[TelProfile]
This ini file table parameter configures the Tel Profile table. Each Tel Profile
ID includes a set of parameters (which are typically configured separately
using their individual, "global" parameters). You can assign these Tel Profile
IDs to the Hunt Group table (TrunkGroup parameter).Therefore, Tel Profiles
allow you to easily apply different behaviors (parameter settings) to different
channels (i.e., ports).
The format of this parameter is as follows:
[TelProfile]
FORMAT TelProfile_Index = TelProfile_ProfileName,
TelProfile_TelPreference, TelProfile_CodersGroupID,
TelProfile_IsFaxUsed*, TelProfile_JitterBufMinDelay*,
TelProfile_JitterBufOptFactor*, TelProfile_IPDiffServ*,
TelProfile_SigIPDiffServ*, TelProfile_DtmfVolume, TelProfile_InputGain,
TelProfile_VoiceVolume, TelProfile_EnableReversePolarity,
TelProfile_EnableCurrentDisconnect, TelProfile_EnableDigitDelivery,
TelProfile_EnableEC, TelProfile_MWIAnalog, TelProfile_MWIDisplay,
TelProfile_FlashHookPeriod, TelProfile_EnableEarlyMedia*,
TelProfile_ProgressIndicator2IP*, TelProfile_TimeForReorderTone*,
TelProfile_EnableDIDWink, TelProfile_IsTwoStageDial,
TelProfile_DisconnectOnBusyTone, TelProfile_EnableVoiceMailDelay,
TelProfile_DialPlanIndex;
[\TelProfile]
For example:
TelProfile 3 = ITSP_acme, 1, 0, $$, $$, 10, 46, 40, -11, 0, 0, 1, 0, 0, 1, 0, 0,
700, 0, -1, 255, 0, 1, 1, 1, -1;
Notes:
 You can configure up to nine Tel Profiles (i.e., indices 1 through 9).
 The parameter TelPreference determines the priority of the Tel Profile (1
to 20, where 20 is the highest priority). If both IP and Tel profiles apply to
the same call, the coders and other common parameters (indicated with
an asterisk) of the preferred Profile are applied to that call. If the
preference of the Tel and IP profiles is identical, the Tel Profile
parameters take precedence.
 The asterisk (*) indicates common parameters used in both IP and Tel
Profiles.
 The parameter EnableVoiceMailDelay is applicable only if voice mail is
enabled globally (using the parameter VoiceMailInterface).
 Assign intuitive names (ProfileName) to the Tel Profiles so that you can
easily identify them later.
 To use the settings of the corresponding global parameter, enter the
value -1.
 To apply default settings to a parameter, enter two adjacent dollar signs
($$).
 For a detailed description of each parameter, refer to its corresponding
"global" parameter.
 For a description of using ini file table parameters, refer to ''Format of ini
File Table Parameters'' on page 273.
To Next Page
Loading...
Need help?
General
