Version 5.8 389 October 2009
SIP User's Manual 6. Configuration Parameters Reference
Parameter Description
Web: IP to IP Outbound Manipulation Table
[IPOutboundManipulation]
This ini file table parameter configures the IP to IP Outbound
Manipulation table. This table allows you to manipulate the SIP
URI user part (source and/or destination) of the outbound
INVITE message. The manipulation rule in the table is located
according to the source IP group, and source and destination
host and user prefixes. The format of this parameter is as
follows:
[ IPOutboundManipulation ]
FORMAT IPOutboundManipulation_Index =
IPOutboundManipulation_IsAdditionalManipulation,
IPOutboundManipulation_ManipulatedURI,
IPOutboundManipulation_SrcIPGroupID,
IPOutboundManipulation_DestIPGroupID,
IPOutboundManipulation_SrcUsernamePrefix,
IPOutboundManipulation_SrcHost,
IPOutboundManipulation_DestUsernamePrefix,
IPOutboundManipulation_DestHost,
IPOutboundManipulation_RemoveFromLeft,
IPOutboundManipulation_RemoveFromRight,
IPOutboundManipulation_LeaveFromRight,
IPOutboundManipulation_Prefix2Add,
IPOutboundManipulation_Suffix2Add;
For example:
IPOutboundManipulation 1 = 0, 0, -1, -1, *, *, *, *, 0, 0, 255, , ;
Notes:
 This table can include up to 100 indices (where 0 is the first
index).
 Manipulated destination SIP URI user names are done on
the following SIP headers: Request URI, To, and Remote
Party ID (if exists). Manipulated source SIP URI user names
are done on the following SIP headers: From, P-Asserted (if
exists), P-Preferred (if exists), and Remote Party ID (if
exists).
 The manipulation rules apply to the SIP INVITE, OPTIONS,
and SUBSCRIBE messages (not REGISTER messages).
 For SIP URI host name (source and destination)
manipulations, use the 'IP Group' table. These host names
are simply replaced with the names configured for the
Source and Destination IP Groups respectively.
 For a detailed description of the table's individual
parameters and for configuring the table using the Web
interface, refer to ''Configuring the IP to IP Outbound
Manipulation Table'' on page 193.
 For a description on configuring ini file table parameters,
refer to ''Format of ini File Table Parameters'' on page 273.
To Next Page
Loading...
Need help?
General
