Chapter 5 Smart Battery 97
Modifying the official smart battery or charging device provided by Autel Robotics is
prohibited.
Only use the battery and charging device provided by Autel Robotics. Autel Robotics is not
responsible for any consequences, such as battery accidents and flight failure, caused by
the use of third-party batteries or charging devices.
Keep the smart battery away from flammable and explosive items during charging.
After the smart battery is fully charged, disconnect the connection between the charger
and the smart battery and power supply promptly.
After flight, it is recommended to wait until the smart battery naturally cools down to an
appropriate temperature before charging the battery. If the temperature of the smart
battery is higher than 40℃
, when the battery is connected to the charging device, the
battery temperature protection function will be activated, and the battery cannot be
charged until its temperature drops below 40
℃
It is recommended to fully charge the smart battery of the aircraft before the aircraft takes
off.
Generally, it takes about 90 minutes to fully charge the smart battery of the aircraft, but the
charging time is related to the remaining battery level.
Table 5-5 Other Battery Indicator Warning Instructions
The temperature is too high for
charging.
The charging current is too high,
which causes a short circuit.
A circuit overcurrent, a circuit
overload, or a short circuit occurs
during battery discharge.
: Indicator light blinking : Off
Storing and Transporting the Smart Battery
When storing the smart battery, keep the battery away from water or heat sources and store it
in a dry, well-ventilated environment at room temperature.
Ideal storage conditions: The battery level is at around 60%, the ambient temperature is between
22℃ to 28℃, and the ambient humidity is 65%±20% RH.
The energy of the MDH_10000_23700 smart battery is 237 Wh (capacity is 10000 mAh). Please
refer to local lithium battery transportation policies for battery shipping or carrying.