Chapter 6 Autel Enterprise App 117
In case of RTK module issues, please manually disable RTK positioning and switch back to
GNSS mode.
When activating RTK positioning during flight, please hover the aircraft and wait for satellite
Check RTK Connection
To check the RTK network status, enable RTK positioning, enter the RTK account, and tap "Log In
Account" to establish the RTK network connection.
If the connection is successful, it will display "Connection Successful."
If there is an issue, it will display "Connection Failed" along with a reason for the failure.
RTK Receive Signal Setting
For setting the RTK signal reception, enter the network RTK server address, port number,
account, password, and mount point in the RTK service configuration section.
Tap "Log In Account" to log in to the network RTK service. If there's an issue with the
configuration, it will provide relevant prompts.
Tap "History Accounts" to view previously configured RTK accounts. The aircraft supports
saving multiple network RTK accounts.
Tap the button on the right side of "Auto Connect" to enable or disable automatic login RTK
accounts.
Check RTK Coordinates
To view the RTK coordinate system, after establishing the RTK network connection, check the
coordinate system type, RTK orientation mode, latitude, longitude, altitude, satellite quantity,
and standard deviation.
More
In the sidebar of the “Settings” interface, tap the “ ” icon to enter the "More" interface, where
you can configure unit settings, light settings, safety, target recognition settings, and the
language settings of the Autel Enterprise App for the aircraft and manually check for updates to
the App or firmware.
To Next Page
Loading...
