Autel Alpha - 6.8.2 “Zoom Camera” Interface

Chapter 6 Autel Enterprise App 127
 If this function is turned on, you can set the time stamp, latitude & longitude and altitude,
and aircraft SN functions. Once this function is enabled, the shot images will include the
set stamp.
 Turn On/Off Pre-recording
Tap the button to the right of "Pre-recording" to turn on or off this function.
 If this function is turned on, the aircraft will start recording 15 seconds in advance (tap the
" " icon).
Tip

The pre-recording function can prevent missing important shots when the aircraft is flying
rapidly.
 Turn On/Off Histogram
Tap the button to the right of "Histogram" to turn on or off the histogram function. The histogram
can display the distribution of pixels in the images captured by the camera, thereby reflecting
the exposure of the images.
 If the histogram function is turned on, a floating "Histogram" window will be generated on
the screen of the remote controller, and you can drag the "Histogram" window to any area
on the screen. Tap the "Close" button in the upper-right corner of the window to turn off
the histogram function.
 Set Storage Location
You can choose "SD Card" or "Internal Storage" as the storage location. Also, you can view the
storage status of "SD Card" and "Internal Storage" and tap "Format" on the right side to format
the corresponding storage location.
 Reset Camera Parameters
Tap the "Reset" button to the right of “Camera Reset” to restore the camera parameters to
default settings.
 View Camera Model
You view the gimbal camera model.
“Zoom Camera” Interface
On the main interface of the Autel Enterprise App, tap the " " icon in the corner of the "Wide
Camera" preview interface, or tap the " " icon after entering the "Thermal Camera" interface
or "Wide Angle Camera" interface, to enter the "Zoom Camera" full-screen interface.