Autel Alpha - 2.15 Standard Flight Operation Process; 2.15.1 Pre-Flight Checklist

Chapter 2 Flight Safety 33
Tip
 Operation path: On the main interface of the Autel Enterprise App, tap “ ” > “ ” > “ ” >
“Safety” > “Remote ID”, and follow the on-
screen instructions to perform relevant
operations. For more information, see “6.5.8 More” in Chapter 6.
Standard Flight Operation Process
Pre-Flight Checklist
Before each flight, please follow the steps below to perform a comprehensive pre-flight check to
ensure flight safety:
 Make sure that the batteries of the aircraft and remote controller are fully charged, and the
two batteries of the aircraft is installed in place, with the battery unlock lever in a lock state.
 Make sure that the propellers of the aircraft are installed properly, tightly without damage or
deformation, the motor and propellers are clean and free of foreign objects, and the
propellers and arms are fully extended.
 Make sure that the microSD card is inserted into the gimbal, and that the rubber protective
cover on the microSD card slot is closed firmly. Otherwise, the protection performance of the
gimbal will be affected.
 Make sure the gimbal camera is well mounted on the aircraft and the gimbal unlock button
is aligned with the lock symbol on the gimbal connector.
 Make sure that gimbal protective cover has been removed, the vision cameras of the aircraft,
the lens of the gimbal, and the lens of the auxiliary light are free from foreign objects, dirt, or
fingerprints, and are not blocked by loads or other accessories on the fuselage.
 Make sure that the three-axis movement of the gimbal is in a normal state.
 Make sure that the rubber protective cover on the fuselage is closed firmly. Otherwise, the
protection performance of the aircraft will be affected.
 Make sure that the antenna of the remote control is unfolded.
 Place the aircraft in an open and flat area outdoors and make sure that there are no obstacles,
buildings, trees, etc. around. You should stand at least 10 meters away from the tail of the
aircraft when operating.
 Make sure that after the aircraft is powered on, the aircraft and the remote controller are
connected, and the aircraft motors, gimbal, and camera are working normally.
 Make sure that the aircraft, remote controller, etc. have been upgraded to the latest version
as prompted.
 Make sure that all warnings and errors displayed on the Autel Enterprise App are handled.
 Enter the Autel Enterprise App setting page to set the flight control parameters, obstacle
avoidance system, stick mode, and other related flight safety parameters, and be familiar with
the flight operation, so as to ensure that the parameter settings meet your own needs and
guarantee flight safety.
 If multiple aircraft are flying at the same time, please keep an appropriate air distance to avoid
any accidents.