Autel Alpha - 7.3 Troubleshooting Guide

Chapter 7 Firmware Updates and Maintenance 153
3
Left Rear Arm
Propeller CW
1
EAN：6924991133407
UPC：889520213400
Autel Robotics
4
Right Rear Arm
Propeller CCW
1
EAN：6924991133414
UPC：889520213417
Autel Robotics
5 Gimbal 1
EAN: 6924991126195
UPC: 889520206198
Autel Robotics
6 Smart Battery 2
EAN: 6924991126201
UPC: 889520206204
Autel Robotics
Tip

You can independently contact Autel Robotics to purchase the aforementioned parts and
follow the operation instructions for replacement.
 If the part that you want to replace is not listed in the above lists, please contact Autel
Robotics. Failures caused by unauthorized disassembly and reassembly will not be covered
by the warranty.
 For the service life of each part, see "Maintenance Manual".
Troubleshooting Guide
Tip

The following troubleshooting measures are only limited to failures resulting from normal
usage.
 For failures resulting from abnormal usage, please contact Autel Robotics for handling.
1. The remote controller cannot power on:
 Check whether the remote controller has sufficient power. If the battery level is too low, it
may result in a power-on failure after shutdown. In this case, fully charge the remote
controller and then power it on.
 Check whether the ambient temperature is suitable, as low temperatures can affect
battery output performance, resulting in a power-on failure.
 If the remote controller was accidentally powered off during an update, it may not power
on normally. In this case, contact Autel Robotics.
 If the remote controller has not been subjected to external impacts, liquid submersion, or
other destructive behaviors and does not have any conditions mentioned above, it may
have a hardware failure. In such cases, contact Autel Robotics.