108 Chapter 6 Autel Enterprise App
If this function is turned off, the aircraft can keep ascending according to your operation until
the battery is exhausted.
The altitude limit should not be set lower than the RTH altitude value.
The altitude limit setting should comply with local (within the flight operation area) laws
and regulations. Flying the aircraft in an unsuitable flight altitude may have legal risks.
Please comply with the fight safety requirements of relevant areas during flight operations.
Turn On/Off Distance Limit
Tap the button on the right side of "Distance Limit" to turn on or off the distance limit function.
If this function is turned on, enter the distance limit value in the edit box of "Distance Limit
(20-5000m)" that pops up below, and the aircraft will fly within a circle with the take-off point
as the center and the distance limit value as the radius.
If this function is turned off, the aircraft can keep moving according to your operation until
the battery is exhausted.
Appropriate altitude limit and distance limit settings can improve flight safety.
Set Flight Mode
Tap the "Flight Mode" drop-down list, and then select the appropriate mode from Slow, Smooth,
Standard, and Ludicrous, that is, set the default speed mode every time you open the Autel
Enterprise App. For the meaning of each mode, see “3.8.2 Flight Modes” in Chapter 3.
Set Home Point
Tap “Aircraft” or “RC” to set the home point.
If "Aircraft" is selected, the home point is the position where the aircraft took off this time.
If "RC" is selected, the home point is the current position of the remote controller.
Note
If the home point is not set, the aircraft will record the take-off point as the default home
point.
Calibrate Compass/ IMU
Perform the calibration operation as instructed in the Autel Enterprise App. For more
information, see “2.11 Aircraft Calibration” in Chapter 2.
Set Lost Action
Tap the drop-down list of "Lost Action" to set the aircraft actions when disconnected.
Lost action refers to the action that the aircraft will perform when the aircraft is disconnected
from the remote controller during flight. By default, the lost action is set to “Return to Home”.
If “Return to Home” is selected, when the aircraft disconnects, the aircraft will automatically
return to the home point.
To Next Page
Loading...
