Autel Alpha - Page 121

110 Chapter 6 Autel Enterprise App
 If this function is turned off, when the aircraft detects an obstacle, it will not stop.
Warning

To ensure flight safety, it is recommended to always turn the OA system on.

When the flight mode of the aircraft is set to “Ludicrous”, the OA system function is
unavailable.
 Set Warning Distance
Enter a value in the edit box to the right of "Warning Distance (1m-10m)", or adjust the value by
moving the slider below left and right. If the aircraft detects an obstacle, it will send a warning at
the warning distance as set.
 Turn On/Off Radar Display
Tap the button to the right of "Radar Display" to turn on or off the radar display function.
 If this function is turned on, when the aircraft detects an obstacle, it will provide risk warnings
on the camera interface based on the set brake/warning distance.
 If this function is turned off, when the aircraft detects an obstacle, it will not provide risk
warnings on the camera interface.
 Turn On/Off Obstacle Detection Notification Sound
Tap the button to the right of "Obstacle Detection Notification Sound" to turn on or off the
obstacle detection notification sound function.
 If this function is turned on, when the aircraft detects an obstacle, it will emit an audible alert.
 Turn On/Off Landing Protection
Tap the button to the right of "Landing Protection" to turn on or off the landing protection
function.
 If this function is turned on, the aircraft will detect whether the ground surfaces are suitable
for landing before it lands.
Tip
 After the landing protection function is turned on, if the aircraft detects that the ground
surface is not suitable for landing, it will keep hovering over the landing point. In this case,
you need to use the command sticks to manually control the aircraft
to land at an
appropriate location.
 OA Mode
Select the desired OA mode from the drop-down list of "OA Mode".
After the OA mode is set, the aircraft will perform the corresponding action when detecting
obstacles. The default OA mode is "Hovering".
 If "Hovering" is selected, when the aircraft detects an obstacle during flight, it will hover at the
current position.
 If "Bypass" is selected, when the aircraft detects an obstacle during flight, it will select an
optimal path to bypass the obstacle.