CHARGING THE LITHIUM POLYMER BATTERY PACK
Charge the battery pack using only the charger provided with MC6. MC6 should never
be left unattended while charging.
The charger operates in the following environments:
Voltage: 100 … 240 VAC
Frequency: 50/60 Hz
Indoor use only, IP 40.
Charge within the following temperature range:
0 °C to 40 °C (32 °F to 104 °F).
Charge MC6 away from flammable items or liquids.
Use the charger in environments containing limited amounts of dust and humidity, e.g.
in a laboratory or an office.
If the battery pack starts to heat up or deform, stop charging process immediately and
disconnect the charger. Place MC6 in a fire proof location and wait for approx. 15
minutes. If no problems occur, try charging again, but be extra careful and oversee how
the charging progresses. It is better to replace a faulty battery pack than risk serious
damages.
Do not continue charging the battery, if it does not recharge within the specified charg-
ing time. Charging time is approximately 4 hours (for 4400 mAh battery pack).
After extended periods of storage, it may be necessary to charge and discharge the
cells or batteries several times to obtain maximum performance.
STORING
When transporting or temporarily storing MC6's battery
pack, store it in 30/40 % charged state. Storing in a fully
charged or discharged state results in substantial capacity
loss, or malfunction of the protection electronics.
Recommended storing temperature for the battery pack is
between -20 °C to 45 °C (-4 °F to 113 °F). The lower the
temperature (but well above freezing point) the better for
keeping up the capacity.
Note.
When MC6 is not used for a longer period, charge MC6 in
3 month periods.
To Next Page
Loading...
