BEAMEX MC6 - Generations;Simulations

14 MC6 User Manual – Part 1, Introduction
HARDWARE MODULES/OPTIONS AND ACCESSORIES
 Internal Pressure Modules. Up to three gauge and/or differential pres-
sure modules may be installed and additionally a barometric module.
 Communicating hardware for MC6's Communicator software options.
See also Software Options on page 13.
 Adapter cables for R2 connector. The R2 connector supports Beamex
Smart Reference Probe.
 Cable for Pressure and Temperature Controllers.
 Soft Carrying Case.
 Hard Carrying Case.
 Spare Battery Pack.
RELATED PRODUCTS
There are an increasing number of devices that can be used together with
MC6. The following list includes devices that are already available (valid when
this manual was printed):
 External Pressure Modules (EXT),
 Calibration hand pumps:
- PGV vacuum pump,
- PGL low pressure calibration pump,
- PGM high pressure pump,
- PGPH high pressure pneumatic pump and
- PGXH extra high pressure pump.
 Beamex POC6 Automatic Pressure Controller,
 Beamex Field Temperature Block (FB Series),
 Beamex Metrology Temperature Block (MB
Series) and
 Beamex CMX Calibration Software.