BEAMEX MC6 - Page 5

MC6 User Manual - Contents iii
Part 7, Communicator
General 60
Warnings .............................................................................. 61
Connections 62
Selecting the Instrument 63
List of Found Devices ........................................................... 63
About Instrument Parameters 64
Instrument Parameters in General ........................................ 64
Calibrating or Data Logging HART instruments .................... 65
Calibrating or Data Logging Fieldbus Instruments ................ 65
Editing Parameters ............................................................... 66
Trimming a Fieldbus instrument ............................................ 67
Trimming a HART instrument ............................................... 68
HART Device Description Specifics 69
General ................................................................................ 69
Basic View ..................................................................... 70
Managing Smart Transmitter Configurations 71
General ................................................................................ 71
Tools in MC6 ........................................................................ 71
Saving Configurations .................................................... 71
Viewing/Managing Configurations .................................. 72
Beamex MC6 Fieldbus Configuration Viewer ........................ 72
Uploading Configurations............................................... 72
Linking Configurations to CMX....................................... 72
Part 8, Settings
Settings 74
Security Plus 75
General ................................................................................ 75
Security Plus in Documenting Calibrator .............................. 76
Part 9, Additional Information
Additional Information 78
User Defined Pressure Units ................................................ 79
User Defined PRT / RTD Sensors ........................................ 80
General ......................................................................... 80
Callendar van Dusen Formula for PRTs ........................ 81
ITS-90 PRT Sensor ....................................................... 81
Factor ............................................................................ 83
Check Sensor Conversion ............................................. 83
User Defined Transfer Functions.......................................... 84
User Defined Steps / Calibration Points ............................... 85
Controller Communication .................................................... 86
What Can be Done With Controller
Communication ............................................................. 86
Configuring Controller Communication .......................... 87
Changing Controller During Calibration ......................... 87