Print Chi-Square Reports
1. From the home screen select <Reports>. Select <Administrative>. Select <QA>.
Select <Chi-Square>.
2. You now have to set the date range for what you want to display and print for
Chi-Square. Once you have selected the starting/ending dates listed as “from/to”, select <accept>
on each one to return to the date range screen. If you want to include the measurements, which
shows the details for each Chi-Square report, check the <include measurements> box. If the
“include measurements” box is not checked, the report will display the date and the Chi-Square
results ONLY. It will not display the individual counts used in the Chi-Square calculation.
3. When the date range is correct, select <accept> to display the Reports.
4. View the report or print by select the <printer> icon. (See reports below.)
Figure 11.8. Chi-Square Summary Report.
!
!
NOTE: You can also print the Chi-Square Summary Report and the Chi-Square Detail Report from the
QA Mode using the Chi-Square History button
Chi-Square Summary Report
Printed on: 4/19/2013 2:40:51 PM
Detector
Detector
S/N
Sample
Time
(sec)
Date Performed
Chi-Square
Value
Result Staff
Probe (Probe)
121
6.26
4/12/2013 2:22:53 PM
Pass
Claude Cho6
Probe (Probe)
121
12.06
4/15/2013 1:59:08 PM
Pass
anna marie6
Johnson Memorial Clinic
20 Hospital Way
Port Jefferson,NY 11967
Page 1 of 1Software Ver: 1.0.66.0
Comments :
Signature : Date Signed :
To Next Page
Loading...
