Tap the ‘skip’ forward button once to move the playhead to the last frame of the current
clip. If the playhead is already at the end of a clip, it will jump to the first frame of the
next clip.
Press and hold the ‘skip’ back and ‘skip’ forward buttons to change them to ‘rewind’
and ‘forward’ shuttle buttons. Now you can use them to change the shuttle speed to
2x, 4x, 8x or 16x.
To reduce the shuttle speed, simply tap the button in the opposite direction.
The shuttle speed indicator displays the speed and direction of footage being fast forwarded or reversed
You can change the playback mode from ‘all clips’ to ‘single clip’ in the ‘setup’ menu. In ‘single
clip’ mode the last recorded clip is displayed when you press ‘play’.
TIP Swipe up or down on your URSA Cine’s touchscreen to hide status text while
playing back footage. Swiping left or right will open the slate where you can mark
the current clip ‘good take’ in metadata. Swipe again to close the slate. For more
information, see the ‘entering metadata’ section in this manual.
Looping Playback
Tapping the play button more than once enables the ‘loop’ feature. Looping can be useful if you
want to continue looping the same clip, or loop all clips on the timeline.
Loop
Once your clip is playing, press the ‘play’ button again to set your camera
to play the current clip on a continuous loop.
Loop all
Tap ‘play’ again to play all your recorded clips on a continuous loop.
Play
Tap again to return to real time playback.
103Touchscreen Controls
To Next Page
Loading...