Blackmagic URSA Cine - Page 67

6 ISO, Shutter and White Balance Switches
These small switches are used to adjust your ISO, white balance, and shutter settings. They
are helpful when you want to make fast adjustments without taking your eyes off the shot.
Gently push the switches up or down to make setting adjustments. Theswitches are spring
loaded so they always return to a neutral position.
ISO
Push this switch up or down to adjust your camera’s ISO setting. Pushing up will increase
the setting one interval, and pushing down will decrease one interval. The available
settings are 200, 400, 800, 1600 and 3200.
Shutter
Use this switch to adjust the camera’s shutter angle or shutter speed, depending on what
you have selected in the setup menu. Pushing up will increase the shutter angle or shutter
speed to the next available preset, and pushing down will decrease the shutter angle or
shutter speed to the next available preset. Holding the switch up or down will move more
quickly through available values. There are twenty shutter angle presets between 11.2and
360 degrees.
TIP Your URSA Cine can also suggest flicker free shutter angles or shutter speeds
based on the power frequency in your region. These must be selected through the
LCDtouchscreen menu. For more information see the ‘touchscreencontrols’ section in
this manual.
White Balance
This switch is used to adjust the camera’s white balance. Pushing up will increase the color
temperature by 50K, and pushing down will decrease it by 50K. Holding the switch up or
down will move more quickly through available values.
7 Function 1, Function 2 and High Frame Rate
The F1 and F2 keys are ‘function’ keys that can be programmed to a variety of commonly
used functions using your URSA Cine’s ‘setup’ menu. By default, F1 is set to ‘focus zoom’
while F2 is set to ‘display LUT’.
For more information, see the ‘touchscreen controls’ section of this manual.
HFR
Use the HFR or high frame rate button to toggle off speed frame rates. To use this button,
simply set the off speed frame rate you’d like to use in your URSA Cine’s ‘frame rate’ menu.
Pressing this button will toggle between your chosen off speed frame rate and project
frame rate. It’s worth mentioning that this setting can only be adjusted when the recording
is stopped. The HFR button also operates as a ‘function key’ that you can program to a
variety of commonly used functions, or can be disabled.
For more information on project and off speed frame rates, see the ‘touchscreen controls’
section in this manual.
8 Menu
Press this button to open the menu settings on the LCD touchscreen when the LCD door
has been flipped and folded against the side of the camera.
9 Record
The ‘record’ button is marked REC on your Blackmagic URSA Cine’s forward control panel.
Pressthe record button to start and stop recording. Refer to the ‘recording’ section for more
information.
67Control Buttons