112 S850 Operation & Maintenance Manual
BACK-UP ALARM SYSTEM
Description
The Back-up Alarm will sound w
hen the operator moves
both steering handles or joystick(s) into the reverse
position. Slight movement of the controls into the reverse
position is required with hydrostatic transmissions, before
the back-up alarm will sound.
Inspecting
Figur
e 157
Inspect for damaged or missing back-up alarm decal
(I
tem 1) [Figure 157]. Replace if required.
Sit in the seat and fasten the seat belt. Engage the
pa
rking brake. Pull the seat bar all the way down. Start
the engine. Press the PRESS TO OPERATE LOADER
button. Disengage the parking brake.
Move both steering handles or joystick(s) into the reverse
po
sition. The back-up alarm must sound when all wheels
or both tracks are moving in reverse.
The back-up alarm is located on the inside of the rear
do
or.
Figure 158
Inspect the back-up alarm electrical connections (Item 1)
an
d wire harness (Item 2) [Figure 158] for tightness and
damage. Repair or replace any damaged components.
NOTE: See your Bobcat dealer for service if your
back-up alarm does not sound.
Dealer Copy -- Not for Resale
To Next Page